The Crimplock® hoop is a hybrid design combining a crimped leg over the WeatherKing® poured channel technology, locking the film into the collar for added strength, durability and tuning consistency in high-tension marching applications. Though some drumset players utilize The Crimplock® drumheads for those benefits they are not required for drum set.
Standard Remo drumheads for drum set, use an open-channel construction which allows the film to relax and vibrate freely promoting optimum tone and resonance, and a wider tuning-range. This design is made to accommodate various counter-hoops and bearing edges out in the market today and has been used by the majority of leading manufacturers since the beginning.
Published:
March 10, 2024
March 2, 2016
Updated:
March 11, 2024
All sizes (12"-22" diameters) are +.130 inches over the advertised drumhead size. For example, a 14" diameter Classic Fit drumhead, has an inner diameter (from aluminum flesh-hoop) of 14.130 inches. Here are a few points to consider when determining if Classic Fit is right for your drums: We designed Classic Fit with a more narrow aluminum flesh-hoop allowing proper seating with the drums counter-hoop, and room to rest on drum shells that either run slightly over sized-due to natural expansion over time or overlapping of the shell wrap finish, or even out-of-round drum shells. Many vintage drum wraps, even some made today, were done in sheets, not rolls. The sheets were too short to cover the entire circumference of bass drums and 18” floor toms. Therefore, these drums had two overlapping seams which make it more difficult for a normal size flesh hoop to fit over the seams. Cut‐a‐way view of a drum shell with one overlapping seam Tom-Toms and Snare Drums that have a thick overlapping seam will interfere with the drumhead flesh hoop, keeping it from moving down over the seam and not allowing the drumhead film to rest on the bearing edge. If the standard drumhead is forced over the shell it will not resonant freely and cause wrinkles in the drumhead film. Remo Standard Batter Head Remo Classic Batter Head with a larger ID and more narrow profile so the countertop fit remains unchanged.
Place the 4 segmented rings on top of the drumhead and form a circle. Lay the drum in a horizontal position with the drumhead facing up. Place the Tray over the Foam. Place the Counterhoop over the Tray. Add Claw Hooks and Tension Rods. Turn the drum over in the vertical playing position. Attach the Bass Drum Pedal. Product subject to change without notice. Visit Remo.com for more information.
Drumhead types are specific to the type of counter-hoop used on the drum. Drums with wooden counter-hoops, most common on bass drums, require a 'bass-type' drumhead which has a wide gauge aluminum flesh-hoop to properly seat and tune up. Drums that use metal counter-hoops, most common on snare and toms, require a non-bass drumhead which has a thinner gauge aluminum flesh-hoop to seat inside. Players have managed to interchange head types in some cases, but it's not likely nor recommended for optimum performance. *We also identify with the part #'s where the 3rd digit is '0' for snare/tom and '1' for bass use. For example: PINSTRIPE® CLEAR DRUMHEAD, 20" PS-0320-00 is for snare/tom style PS-1320-00 is for bass style.