Tuning your drum set involves adjusting the tension of both the batter (top) and resonant (bottom) drumheads to achieve the desired sound. Start by applying even tension to all the tuning rods around the drum, ensuring that both heads are in tune with themselves by tapping near each lug. For the resonant head, tuning it slightly higher (about ½ step) than the batter head produces clearer overtones, longer sustain, and a more focused sound. When tuning your toms, aim for a balanced tone that complements the rest of your kit. The snare drum benefits from a higher, tighter tension, while the bass drum typically uses lower tension for a deeper, punchier tone. Remember, drum tuning is subjective, so experiment with different tensions until you find the sound that suits your playing style and musical context.
Published:
July 20, 2024
August 3, 2023
Updated:
September 11, 2024
September 11, 2024
For over 65 years, Remo has been a leader in drumhead technology, chosen by top drum manufacturers for its quality and innovation. Leading brands like DW, Ludwig, Yamaha, and Pearl, along with custom makers and percussion specialists, trust Remo to deliver superior drumheads. These partnerships ensure high-quality sound for drummers worldwide.
Batter drumheads are the ones you strike and are available in different thicknesses and features to match your desired sound and playing style. Resonant drumheads, found on the bottom of the drum, enhance tone and sustain, with thinner versions used for greater sensitivity, especially on snare drums. Choosing the right drumhead depends on the drum type and the sound you want to achieve.
All sizes (12"-22" diameters) are +.130 inches over the advertised drumhead size. For example, a 14" diameter Classic Fit drumhead, has an inner diameter (from aluminum flesh-hoop) of 14.130 inches. Here are a few points to consider when determining if Classic Fit is right for your drums: We designed Classic Fit with a more narrow aluminum flesh-hoop allowing proper seating with the drums counter-hoop, and room to rest on drum shells that either run slightly over sized-due to natural expansion over time or overlapping of the shell wrap finish, or even out-of-round drum shells. Many vintage drum wraps, even some made today, were done in sheets, not rolls. The sheets were too short to cover the entire circumference of bass drums and 18” floor toms. Therefore, these drums had two overlapping seams which make it more difficult for a normal size flesh hoop to fit over the seams. Cut‐a‐way view of a drum shell with one overlapping seam Tom-Toms and Snare Drums that have a thick overlapping seam will interfere with the drumhead flesh hoop, keeping it from moving down over the seam and not allowing the drumhead film to rest on the bearing edge. If the standard drumhead is forced over the shell it will not resonant freely and cause wrinkles in the drumhead film. Remo Standard Batter Head Remo Classic Batter Head with a larger ID and more narrow profile so the countertop fit remains unchanged.